Wind Sensor Testing

UPDATE2: yeah ignore the drivel in this post and check this post for correct equation for the anemometer.

UPDATE: So it turns out that I haven’t a clue about how you measure wind speed with an anemometer. I found the datasheet for the sensors, which gives 1.492mph per pulse on the anemometer over 1 second, so I have had to rework the equation and procedure below. So the screen shot below gives wrong values, but is an example of the scripts output.

Just started testing with theĀ Anemometer N96FY. I have the anemometer connected to GPIO pin 18 and 3.3 volt supply. This wind sensor is like a switch and it’s default state is closed, meaning electricity with flow through the anemometer except for two opposing points during a full revolution where the voltage will briefly fall to zero.

I work out the equation to be

wind speed = half the circumference / time taken

Wind speed will be in metre per second. Half the circumference is 0.21994 metres.



One thought on “Wind Sensor Testing

  1. Thanks for writing the wind sensor code (3 years ago!). Very helpful getting me started doing something very similar šŸ™‚

Leave a Reply

Your email address will not be published. Required fields are marked *